Siemens SINUMERIK 840DE sl Commissioning Manual page 644

Technologies and cycles
21.10 Measuring cycles and measurement functions
MD51752 $MNS_J_MEA_M_DIST_TOOL_LENGTH
= 2
MD51753 $MNS_J_MEA_M_DIST_TOOL_RADIUS
= 1
MD51786 $MNS_J_MEA_T_PROBE_MEASURE_DIST
= 10
General cycle setting data when measuring with rotating spindle
SD54670 $SNS_MEA_CM_MAX_PERI_SPEED[0]
= 100
SD54671 $SNS_MEA_CM_MAX_REVOLUTIONS[0]
= 1000
SD54672 $SNS_MEA_CM_MAX_FEEDRATE[0]
= 20
SD54673 SNS_MEA_CM_MIN_FEEDRATE[0]
= 1
SD54674 $SNS_MEA_CM_SPIND_ROT_DIR[0]
= 4
630
Default value
Default value
Default value
Default value
Default value
Default value
Default value
Spindle rotation the same as M4 (default value)
Measuring path to measure the tool
length.
Measuring path to measure the tool ra‐
dius.
Measuring path to calibrate the probe
or for measurements with stationary
spindle.
Maximum permissible peripheral
speed of the tool to be measured.
Maximum permissible tool speed of the
tool to be measured. The speed is au‐
tomatically reduced when exceeded.
Maximum permissible feedrate to
probe the tool to be measured at the
probe.
Minimum feedrate for the first probing
of the tool to be measured at the probe.
This avoids excessively small fee‐
drates for large tool radii.
Spindle direction of rotation to measure
tools.
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
SINUMERIK Operate (IM9)