Siemens SINUMERIK 840DE sl Commissioning Manual page 647

21.10.3.3 Measuring tools at the turning machines
Measuring feedrate for tool measurement in turning operation
SD55628 $SCS_MEA_TP_FEED_MEASURE
= 300
Note
Measuring feedrate for tool measuring
All measuring cycles use the value saved in SD54636 or SD54651 as the measuring feedrate
after the tool probe has been calibrated. A different measuring feedrate can be assigned for
each calibration field [n].
When calibrating the probe, either the measuring feedrate from SD55628 is used, or the
measuring feedrate can be overwritten in the input screen when calibrating. To do this,
SD54762 $SNS_MEA_FUNCTION_MASK_TOOL bit 4 must be set to 1.
General cycle machine/setting data for measuring path/feedrate
SD42950 $SC_TOOL_LENGTH_TYP
= 0
= 2
MD51786 $MNS_J_MEA_T_PROBE_MEASURE_DIST
= 10
SD55628 $SCS_MEA_TP_FEED_MEASURE
= 300
Calibrating tool probes
Use the following general cycle machine data to set the access level as of which the "Calibrate
probe" softkey is displayed. This requires that the automatic tool measurement is enabled
using the setting data SD54782 (bit 2 = 1).
MD51070 $MNS_ACCESS_CAL_TOOL_PROBE
= 7
SINUMERIK Operate (IM9)
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
Default value
Measuring turning tools, type 5xx (default value)
Measuring turning tools, type 5xx, drilling and milling tools, type 1xx, 2xx
Default value
Default value
Access rights: Access level 7 (keyswitch 0)
21.10 Measuring cycles and measurement functions
Calibrate measuring feedrate for tool
probe and measure tool with station‐
ary spindle.
Assignment of the tool length offset
independent of tool type.
Measuring path to calibrate the
probe or for measurements with sta‐
tionary spindle.
Feedrate for the calibration of a tool
probe with stationary spindle.
Calibrate tool probe access level.
Technologies and cycles
633