Siemens SINUMERIK 840DE sl Commissioning Manual page 546

Technologies and cycles
21.5 Turning
[1]
[2]
MD53241 $MAS_SPINDLE_CHUCK_TYPE[ ]
= 0
= 1
Additional settings
The M code, e.g. M34 or M1 = 34 for the spindle chuck is defined in the following machine
data. The manufacturer cycle CUST_TECHCYC.SPF also takes the M functions from the
following machine data:
MD52250 $MCS_M_CODE_CHUCK_OPEN[ ]
[0]
[1]
MD52251 $MCS_M_CODE_CHUCK_CLOSE_OPEN_ROT[ ]
[0]
[1]
MD52252 $MCS_M_CODE_CHUCK_CLOSE[ ]
[0]
[1]
MD52253 $MCS_M_CODE_TAILSTOCK_FORWARD[ ]
[0]
[1]
MD52254 $MCS_M_TAILSTOCK_BACKWARD[ ]
[0]
[1]
Contour turning (CYCLE952)
SD55212 $SCS_FUNCTION_MASK_TECH_SET
Bit 3
532
Stop dimensions
Jaw dimensions
Clamping, outer
Clamping, inner
Main spindle
Counterspindle
Main spindle
Counterspindle
Main spindle
Counterspindle
Quill opposite the main spindle
Quill opposite the main spindle
Quill opposite the main spindle
= 6
Delete programs generated by contour cycles (CYCLE63, CYCLE64, CYCLE952)
= 0 Generated programs are not deleted (compatibility as before)
= 1 Generated programs are deleted as soon as they have been executed by the calling cycle.
Spindle jaw type
M code for open chuck with station‐
ary spindle
M code for open chuck with spindle
rotating
M code for close chuck
M code for quill forward
M code for quill back
General function screen for all technologies
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
SINUMERIK Operate (IM9)