Siemens SINUMERIK 840DE sl Commissioning Manual page 573

References
● "siemensd.txt" file in the supplied software (standard cycles)
● Function Manual Basic Functions; W1: Tool offset
Section: "Tool holder with orientation capability" > "Oblique machining with 3 + 2 axes"
● Programming Manual, measuring cycles: CYCLE996
Activating the swivel function
The swivel function is enabled on the user interface via the following channel-machine data:
MD52212 $MCS_FUNCTION_MASK_TECH
Bit 0 = 1
Configuring input screens
You can configure the input screen for swiveling using the following channel-specific cycle
setting data. The setting data is effective for all of the declared swivel data sets.
SD55221 $SCS_FUNKTION_MASK_SWIVEL_SET
Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
Bit 7
SINUMERIK Operate (IM9)
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
Enable swivel
Input field "No swiveling"
= 0 Hide
= 1 Display
Select text when retracting "Z, ZY" or "Fixed position 1/2"
= 0 Display text Z = "Z", display text Z, XY = "Z,XY"
= 1 Display text Z = "Fixed point 1", Display text Z, XY = "Fixed point 2".
If you wish to modify the retraction version "Z" or "Z, XY" via the manufacturer cycle
CUST_800.SPF, the neutral text "Fixed point 1" and "Fixed point 2" can be displayed.
Select, permit "deselection" of the swivel data set
= 0 If deselection is not permitted, the "Swivel data set" (TC) selection field is not displayed
in the "Swivel" input screen.
= 1 Deselection permitted
see also swivel data set parameter $TC_CARR37
HUNDRED MILLIONS position
Displays the active swivel plane under swivel in JOG. The setting in the swivel function
screen acts on all swivel data sets.
Positioning in the basic position (pole position) of the kinematics
= 0 Evaluation of the input values in pole position of the machine kinematics
= 1 Compatibility
Tool alignment absolute or via frame calculation
= 0 Tool alignment via frame calculation (TCOFRY for G18)
= 1 Tool alignment absolute (TCOABS)
For B axis kinematics of a turning machine, the tool spindle can be set in the basic position
of the kinematics, either parallel to Z or to X. Therefore the function "Align milling tool" is
required for rotary milling machine bit 5 = 1.
Do not list swivel mode "direct" under swivel in JOG
Swivel plane: Direction selection in basic position of the kinematic
Technologies and cycles
Cross-technology function screen
Function screen, swiveling CYCLE800
21.7 Swiveling
559