Siemens SINUMERIK 840DE sl Commissioning Manual page 639

Checking and setting the general machine data
MD11450 $MN_SEARCH_RUN_MODE
Bit 1 = 1
MD11604 $MN_ASUP_START_PRIO_LEVEL
= 1 - 64
Setting channel-specific machine data
MD20050 $MC_AXCONF_GEOAX_ASIGN_TAB[ ]
[0]
[1]
[2]
MD20110 $MC_RESET_MODE_MASK
= 4045H
Bit 0 = 1
Bit 2 = 1
Bit 6 = 1
Bit 14 = 1
MD20112 $MC_START_MODE_MASK
= 400H
Bit 6 = 0
MD20310 $MC_TOOL_MANAGEMENT_MASK
= 4002H
Bit 1 = 1
Bit 14 = 1
MD28082 $MC_SYSTEM_FRAME_MASK
Bit 0 = 0
Bit 0 = 1
SINUMERIK Operate (IM9)
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
Automatic ASUB start after output of the action blocks (see also
MD11620 $MN_PROG_EVENT_NAME). Alarm 10208 is not output until the ASUB is
completed.
Priorities for ASUP_START_MASK.
For measuring in JOG mode, all of the geometry axes must be available. Preferably XYZ.
Minimum value
Basic control setting after power on and reset.
Minimum value
Definition of the basic control setting after NC start.
Minimum value
Tool manager and monitoring functions active
Automatic tool change for RESET and Start.
Do not setup system frames for actual value setting and scratching.
Setup system frames for actual value setting and scratching.
21.10 Measuring cycles and measurement functions
"Search run" programming.
Priorities from which ASUP_START_MASK is
effective.
Assignment, geometry axis to channel axis.
Defines the basic control settings after reset /
TP end,
Definition of the basic control setting after part
program start.
Activates tool manager functions
System frames (SRAM).
Technologies and cycles
625