Siemens SINUMERIK 840DE sl Commissioning Manual page 188

Tool management
12.2 Configuring the user interface
Entries
AdaptTransDataViewEnabled
ActiveCompensationsEnabled
M2NLockEnabled
SDToolLengthInListEnabled
DisableMultiTools
CursorPositionInfoEnabled
EnableMonAndBasisGrindingToolTypes True - enable switchover of grinding tool types in respect of
ErrorMessageWithoutProgressBar
ColumnZoomByResolution
AccessLevelReadDetailsAllParameter
FixNumberOfMultiToolPlaces
174
Meaning
The magazine location adapter transformed display of the
cutting edge parameters is enabled. It can be switched on
and off in the settings dialog of the tool lists.
False - default setting, the magazine location adapter trans‐
formed display of the cutting edge parameters is not ena‐
bled.
The "Working offsets" function is enabled. This function de‐
pends on the machine configuration. Unique D number,
magazine location adapter and magazine management
must be set.
False - default setting, the "Working offsets" function is not
enabled.
Locking of an M to N switchover while a function of the tool
management is being executed.
True - default setting, switchover is locked.
True - default setting, evaluation of SD42940, SD42942,
and SD42950 in axis name display in the tool lists.
False - the setting data are not evaluated in the axis name
display.
True - even though the Multitools function is set in the NC,
they are not offered in the tool lists.
False - default setting, if the Multitools function is set in the
NC, they are offered in the tool lists.
True - information about the tool on which the cursor is posi‐
tioned is written to the SlCap local variable "/Hmi/TMHMI‐
CurData".
False - default setting, no information about the tool on
which the cursor is positioned is made available on an in‐
terface for the OA.
"with/without grinding-specific tool monitoring," "with/with‐
out consideration of the base dimension when calculating
the grinding wheel radius."
False - default setting, switchover not enabled.
True - error messages are output without a progress bar
and must be acknowledged via softkey.
False - default setting, error message is automatically
closed when the progress bar reaches the end.
True - column width is adapted to the resolution of the HMI.
False - default setting, the column width is adapted to the
font size in the HMI. With this setting, with higher resolutions
more columns can be displayed next to each other without
needing to scroll.
The following entry specifies the access level as of which
the "Further details" function is offered in the "Details" dialog.
Default setting: Access level 7 (keyswitch position 0) - can
be overlaid through the setting in MD51198.
Multitools are created with a fixed number of multitool loca‐
tions. There is no prompt when you create the multitool.
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
SINUMERIK Operate (IM9)