Siemens SINUMERIK 840DE sl Commissioning Manual page 651

Requirement
You have already made the settings from the following section:
See also: Measuring cycles and measurement functions, general (Page 617)
Settings
General cycle setting data
SD54760 $SNS_MEA_FUNCTION_MASK_PIECE
Bit 1
Bit 3
Bit 4
Bit 6
Bit 7
Bit 8
Bit 9
Bit 10
Bit 11
Bit 12
Bit 13
Bit 14
Bit 15
Bit 16
Bit 17
Bit 18
Bit 19
Bit 20
Bit 21
Bit 22
Bit 24
Bit 25
Bit 26
Bit 27
Bit 28
Channel-specific cycle setting data
SD55630 $SCS_MEA_FEED_MEASURE
= 300
SINUMERIK Operate (IM9)
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
Display select softkey 3D measurement
Enable probe calibration field to be selected
Select calibration input measuring feed
Enable NP correction in the basis reference (SETFRAME) to be selected
Enable NP correction in channel-specific basic frame to be selected
Enable NP correction in global basic frame to be selected
Enable NP correction in adjustable frame to be selected
Enable NP correction coarse and fine to be selected
Select tool offset, geometry and wear
Select tool offset, not inverted and inverted
Select tool offset L1, R or L1, L2, L3 R
Select tool offset, zero offset (_TZL)
Select tool offset, dimensional difference monitoring (_TDIF)
Select workpiece measurement with spindle reversal
Selects align workpiece probe in the switching direction
Select number of measurements (_NMSP)
Select offset with mean value generation (_TMV)
Select experience values (_EVNUM)
Select total setting-up offset
Select calibration to unknown or to known center point
Select calibration with/without position deviation
Select zero offset when measuring the angulation of the spindle
Selects tool offset, do not enable
Selects measure tolerance of the linear vector for kinematics, do not enable
Enable tool offset adjust length to be selected
Measuring feedrate when calibrating the workpiece probe
21.10 Measuring cycles and measurement functions
Settings for the input screen, measuring
cycles in AUTOMATIC, workpiece meas‐
urement.
1)
1)
Measuring feedrate [mm/rev]
Technologies and cycles
637