Siemens SINUMERIK 840DE sl Commissioning Manual page 139

Accept STAT and TU
If you want to import the joint position of the machine and the position of the rotary axes into
the traversing block for Teach In for Cartesian PTP traversing, click on the checkboxes STAT
and TU in the "Settings" window under "Prog. teach in".
The checkboxes are only displayed if the following general configuration machine data is set
to ≠ 0:
MD52032 $MNS_STAT_DISPLAY_BASE
= 0
= 2
= 10
= 16
MD52033 $MNS_TU_DISPLAY_BASE
= 0
= 2
= 10
= 16
8.8 Block search
8.8.1 Activating block search mode
Block search mode settings
The following machine data can be used to set the possible variants for the block search with
G-code programming:
MD51028 $MNS_BLOCK_SEARCH_MODE_MASK
Bit 0 = 1
Bit 1 = 1
Bit 4 = 1
Bit 5 = 1
The following machine data can be used to set the possible variants for the block search in a
JobShop program (ShopMill, ShopTurn):
MD51024 $MNS_BLOCK_SEARCH_MODE_MASK_JS
Bit 0 = 1
SINUMERIK Operate (IM9)
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
no display
Display as binary value (default)
Display as decimal value
Display as hexadecimal value
no display
Display as binary value (default)
Display as decimal value
Display as hexadecimal value
Block search with calculation, without approach
Block search with calculation, with approach
Block search without calculation
Block search with test run
Block search with calculation, without approach (default setting)
Customizing the "Machine" operating area
Number base for display of the joint position STAT
Number base, display of the rotary axes TU posi‐
tion
Bit mask for the available search modes
Bit mask for the available search modes
(ShopMill, ShopTurn, single-channel)
8.8 Block search
125