Siemens SINUMERIK 840DE sl Commissioning Manual page 634

Technologies and cycles
21.10 Measuring cycles and measurement functions
MD54740 $SNS_MEA_FUNCTION_MASK
Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
Bit 16
Bit 17
Bit 19
MD55740 $SCS_MEA_FUNCTION_MASK
Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
Bit 7
Bit 8
Bit 9
Bit 10
Bit 11
Bit 15
Bit 16
Bit 17
Bit 19
Bit 28
Bit 29
21.10.2 Manufacturer and user cycle CUST_MEACYC.SPF
Function
The CUST_MEACYC.SPF is part of the measuring cycle functionality. It is called in every
measuring cycle before and after executing the measurement task. The CUST_MEACYC.SPF
acts in the same way when measuring in the JOG mode and measuring in the AUTOMATIC
mode.
620
Workpiece, repeat measurement if TSA, TDIF exceeded
Workpiece, repeat measurement with M0 if TSA, TDIF exceeded
Workpiece, stop at M0 if TUL, TLL exceeded
Workpiece, accept calibrated probe sphere radius in tool data
Workpiece, plane can vary between calibration and measurement
Tool, repeat measurement if TDIF, TSA exceeded
Tool, repeat measurement with stop at M0 if TDIF, TSA exceeded
Tool, milling, reduction of spindle speed during last probing
Workpiece, collision monitoring for intermediate positioning
Workpiece, coupling of spindle position with coordinate rotation around the infeed axis
Workpiece, reverse positioning direction if spindle position is coupled
Workpiece, no repetition if probe does not switch
Workpiece, 1st probing for every measurement with rapid measuring feedrate
Workpiece, rapid retraction following measurement
Workpiece, deactivate probe during spindle positioning
Kinematics, scaling on the basis of the input values of the rotary axis vectors
Kinematics, measuring with swiveling (TCARR) or active TRAORI
Kinematics, user-specific scaling of the rotary axis vectors
Kinematics, measure completely with reference
Kinematics, number of measurement points when measuring calibration sphere
Workpiece, calibrating radius with starting point in center of ring, JOG mode only
Tool, collision monitoring for intermediate positioning
Tool, no repetition if probe does not switch
Tool, rapid retraction following measurement
Continuous measuring standard log in JOG (attach)
Table format for measuring standard log in JOG
Measuring cycles function screen
Measuring cycles function screen
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
SINUMERIK Operate (IM9)