Siemens SINUMERIK 840DE sl Commissioning Manual page 106

Channel menu
6.7 Distribution via job lists in the case of 1:N
; Select B.MPF on NCU2 in channel 2.
SELECT B.MPF ch=NCU2,2
Sequence:
1. If a distributed job list is active during the selection, all distributed programs on the NCU
are deleted without confirmation. If the workpiece on the NCUs is empty, it will be deleted
there.
2. The programs are copied to the corresponding workpieces of the relevant NCU.
3. Existing programs are overwritten without any message.
4. Following a change in a distributed program on the local drive, the modified programs using
the Editor are copied to the corresponding NCU.
Sample structure
/user/sinumerik/data/ prog/
JOBA.WPD
JOBA.JOB
A.MPF
B.MPF
UP1.SPF
UP2.SPF
/user/sinumerik/data/ prog/
wks.dir/JOBA.WPD
JOBA.JOB
A.MPF
B.MPF
UP1.SPF
UP2.SPF
Supplementary conditions
Special behavior:
● Distributed programs are retained during a restart of the operating software.
● On the local drive, distributed programs can neither be deleted nor renamed nor overwritten
using copy/move.
● Changes of distributed programs on the NCU are lost, if they are not manually saved.
● The program correction in the machine is not offered.
● When creating a commissioning archive, all data of the local drive is also automatically
saved.
92
NCU1
WKS.DIR
WKS.DIR/JOBA.WPD
WKS.DIR/JOBA.WPD/B.MPF
JOBA.WPD/UP1.SPF
WKS.DIR/JOBA.WPD/UP2.SPF
NCU1
WKS.DIR
WKS.DIR/JOBA.WPD
WKS.DIR/JOBA.WPD/B.MPF
JOBA.WPD/UP1.SPF
WKS.DIR/JOBA.WPD/UP2.SPF
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
NCU2
WKS.DIR
WKS.DIR/JOBA.WPD
WKS.DIR/JOBA.WPD/B.MPF
JOBA.WPD/UP1.SPF
WKS.DIR/JOBA.WPD/UP2.SPF
NCU2
WKS.DIR
WKS.DIR/JOBA.WPD
WKS.DIR/JOBA.WPD/B.MPF
JOBA.WPD/UP1.SPF
WKS.DIR/JOBA.WPD/UP2.SPF
SINUMERIK Operate (IM9)