Siemens SINUMERIK 840DE sl Commissioning Manual page 178

Tool management
12.1 Machine data for tool management
Setting with magazine management
Make the following settings if you are commissioning the tool management with NC magazine
management:
MD18080 $MN_MM_TOOL_MANAGEMENT_MASK
= 03H
Bit 0
Bit 1
MD20310 $MC_TOOL_MANAGEMENT_MASK
= 03H
Bit 0
Bit 1
MD17530 $MN_TOOL_DATA_CHANGE_COUNTER
= 1FH
Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
MD28450 $MC_MM_TOOL_DATA_CHG_BUFF_SIZE
= 400
MD19320 $ON_TECHNO_FUNCTION_MASK
= 10H
Bit 4
12.1.2 Configuring the access levels of the tool management
Access levels for selected parameters
MD51199 $MNS_ACCESS_WRITE_TM_GRIND
MD51200 $MNS_ACCESS_WRITE_TM_GEO
MD51201 $MNS_ACCESS_WRITE_TM_WEAR
MD51202 $MNS_ACCESS_WRITE_TM_WEAR_DELTA
164
Provide tool management data.
Provide monitoring data.
Magazine management active.
Monitoring functions of tool management active.
Tool status change.
Tool remaining unit quantity change.
Tool data change service.
Magazine data in the change service.
ISO data in the change service.
Number of entries in the buffer for the OPI change service for tool data. Dynamic memory
is used. This buffer is only created if either bit 2 or bit 3 is set in MD17530 $MN_TOOL_DA‐
TA_CHANGE_COUNTER.
Enables the tool monitoring function with magazine management.
Memory for the tool management is re‐
served step-by-step (SRAM).
Activating the tool management functions.
Marking the changed tool data for HMI.
Buffer for changing tool data (DRAM).
Access level, write TM grinding data.
Access level, write TM geometry data.
Access level, write TM wear data.
Access level, restricted writing of tool
wear values.
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
SINUMERIK Operate (IM9)