Installing Gsdml; Connect Converter To Ethernet/Ip - Siemens SINAMICS G120X Operating Instructions Manual

Infrastructure converter for hvac/water/wastewater

Hide thumbs Also See for SINAMICS G120X:

Table of Contents

PROFINET or PROFIBUS, with Safety Integrated (via terminal) and HMI

support.industry.siemens.com/cs/ww/en/view/60441457)

PROFINET or PROFIBUS, with Safety Integrated (via terminal) and HMI

support.industry.siemens.com/cs/ww/en/view/78788716)

Installing GSDML

1. Save the GSDML to your PC.

– With Internet access:

– Without Internet access:

2. Unzip the GSDML file on your computer.

3. Import the GSDML into the engineering system of the controller.

You have now installed the GSDML in the engineering system of the controller.

To connect the converter to a control system via Ethernet, proceed as follows:

1. Connect the converter to the control system via an Ethernet cable.

2. Create an object for data exchange.

You have the following options:

– Load the EDS file into your controller if you want to use the ODVA profile.

– If your controller does not accept the EDS file, or if you wish to use the SINAMICS profile,

You have connected the converter to the control system via EtherNet/IP.

SINAMICS G120X converter

Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC

Controlling the speed of a SINAMICS G110M/G120/G120C/G120D with S7-300/400F via

Controlling the speed of a SINAMICS G110M / G120 (Startdrive) with S7-1500 (TO) via

GSDML (https://support.industry.siemens.com/cs/ww/en/view/109763250)

Insert a memory card into the converter.

Set p0804 = 12.

The converter writes the GSDML as a zipped file (*.zip) into directory /SIEMENS/

SINAMICS/DATA/CFG on the memory card.

You can find the EDS file on the Internet:

EDS (https://support.industry.siemens.com/cs/ww/de/view/78026217)

you must create a generic module in your controller:

Create generic I/O module (Page 240)

4.2 Control interfaces