Table of Contents
Advertisement
Note
Parameter p60000 is an image of parameter p2000 in conformance with PROFIdrive. A change always effects both
parameters.
If a BICO interconnection is established between different physical quantities, then the particular reference quantities
are used as internal conversion factor.
Example:
The setpoint from PROFIBUS (r2050[1]) is connected to a speed setpoint (e.g. p1070[0]). The actual input value is
cyclically converted into a percentage value via the pre-specified scaling 4000 hex. This percentage value is converted
to the absolute speed setpoint using the reference speed (p60000).
The setpoint from PROFIBUS (r2060[1]) is connected to a speed setpoint (e.g. p1155[0]). The actual input value is
cyclically converted into a percentage value via the pre-specified scaling 4000 0000 hex. This percentage value is
converted to the absolute speed setpoint using the reference speed (p60000).
r61000[0...239]
PROFINET Name of Station / PN Name of Station
G120X_PN
Access level: 3
Can be changed: -
Unit group: -
Min:
-
Description:
Displays PROFINET Name of Station.
NOTICE
An ASCII table (excerpt) can be found, for example, in the appendix to the List Manual.
r61001[0...3]
PROFINET IP of Station / PN IP of Station
G120X_PN
Access level: 3
Can be changed: -
Unit group: -
Min:
-
Description:
Displays PROFINET IP of Station.
SINAMICS G120X converter
Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC
Calculated: -
Scaling: -
Unit selection: -
Max:
-
Calculated: -
Scaling: -
Unit selection: -
Max:
-
Parameters
7.2 Parameter list
Data type: Unsigned8
Dynamic index: -
Function diagram: 2410
Factory setting:
-
Data type: Unsigned8
Dynamic index: -
Function diagram: 2410
Factory setting:
-
935
Advertisement
Table of Contents
