Rep 6.1 Exposure Lamp; Rep 6.2 Lens - Xerox 3001 Service Manual

REP 6.1 EXPOSURE LAMP REP 6.2 LENS
REPLACEMENT
PARTS LlST ON PL 6.1
REPLACEMENT
Q
Ensure that the heatsink is in place in
the center of the exposure lamp and
i t is not touching the rear document
drive rolls shaft.
Q Ensure that the lamp part number is
at the right side of the machine.
1. ENTER THE DIAGNOSTIC MODE.
WARNING
There will be a time delay between the time
the code
[lo]
is entered and the time the
motor starts to turn. The motor will not start
until the fuser is at the correct temperature.
2. USING THE ARROW BUTTONS, ENTER THE
CODE
[lo].
PRESS THE Start BUTTON.
3. USING THE ARROW BUTTONS, ENTER THE
CODE [ I S ] . PRESS THE Start BUTTON.
4. ALLOW THE COPIER TO RUN FOR FOUR
MINUTES TO PREPARE THE NEW LAMP
FOR USE.
5. PRESS THE Stop BUTTON.
6.
PERFORM THE ELECTROSTATIC SERIES
(ADJ
9.2)
PARTS LlST ON PL 6.1
REMOVAL
1. WARNING: DISCONNECT THE POWER
CORD.
2. REMOVE THE DOCUMENT HANDLER.
3.
REMOVE THE PLATEN.
4. REMOVE THE EXPOSURE LAMP.
5. (FIGURE 1): REMOVE THE LENS.
1. (FIGURE 2): THE CORRECT LENS POSITION.
Q STEP 1 A: There are six slots in the
frame into which the lens pins can be
installed. The slots i n the upper
position are for the 3001. Locating
the lens pins in the lower slots will
cause an out of focus condition. in the
300 1.
VlEW FROM THE REAR
j p , SM 4
H"iS"I
Figure 2. The Correct Lens Position
VlEW FROM THE REAR
Figure 1. Remove the Lens
12/98
3001 4-9
REP 6.1, REP 6.2