DGS-3620 m/ mSW Rls. 1.02.000
4-4 ip igmp query-interval
ip igmp query-interval SECONDS
no ip igmp query-interval
Syntax Description
SECONDS
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# interface vlan 1
Switch(config-if)# ip igmp query-interval 120
CLI Reference Guide
Use this command to configure the query interval of an ordinary member. Use
the no form to set the query interval of ordinary member to the default value.
Query interval of ordinary member, in second. The range is 1 to 31744 seconds.
125 seconds
Interface configuration mode
The time to query an ordinary member can be changed by configuring the query
interval of the ordinary member.
Use command show ip igmp interface to verify your setting.
Configure the query interval of ordinary member to 120 seconds on the interface
VLAN 1.
ip igmp query-interval
211