DES-7200 CLI Reference Guide
Default
configuration
Command
mode
Usage
guidelines
Examples
Related
commands
57.1.2
vrrp delay
Use this command to set the reload latency of the VRRP group on the interface.
vrrp delay { minimum min-seconds | reload reload-seconds }
no vrrp delay
Parameter
description
By default, the VRRP function is not enabled on the
the VRRP function is enabled, no authentication password is
configured by default.
Interface configuration mode.
The devices in the same VRRP group must have the same
authentication password configured. The plaintext authentication
password cannot provide security. It aims only to prevent/prompt the
incorrect VRRP configuration.
The example below sets the authentication password for VRRP group
1.
vrrp 1 authentication x30dn78k
Command
DES-7210(config-if)# vrrp
group ip
ipaddress [ secondary ]
Parameter
Description
min-seconds
When the interface is up, VRRP group
shall
min-seconds.
The reload latency of the VRRP group.
If the configured min-seconds is more
reload-seconds
than reload-seconds, the actual reload
latency of the VRRP group will be
min-seconds.
Chapter 57 VRRP Configuration Commands
Description
Enable the VRRP function
and set the IP address for
the virtual device.
be
reloaded
after
interface.
Even if
at
least
57-21