Set Igmp Groupmembership-Interval; Set Igmp Maxresponse - D-Link DWL-8500AP Command Reference Manual

set igmp groupmembership-interval

This command sets the IGMP Group Membership Interval time on a VLAN, one interface or
all interfaces. The Group Membership Interval time is the amount of time in seconds that a
switch waits for a report from a particular group on a particular interface before deleting the
interface from the entry. This value must be greater than the IGMPv3 Maximum Response
time value. The range is 2 to 3600 seconds.
Default
Format
Modes
Format
Modes
no set igmp groupmembership-interval
This command sets the IGMPv3 Group Membership Interval time to the default value.
Format
Modes
Format
Mode

set igmp maxresponse

This command sets the IGMP Maximum Response time for the system, or on a particular
interface or VLAN. The Maximum Response time is the amount of time in seconds that a
switch will wait after sending a query on an interface because it did not receive a report for a
particular group in that interface. This value must be less than the IGMP Query Interval time
value. The range is 1 to 3599 seconds.
Default
Format
Modes
Format
Mode
no set igmp maxresponse
This command sets the max response time (on the interface or VLAN) to the default value.
Format
Modes
260 seconds
set igmp groupmembership-interval <2-3600>
Interface Config
Global Config
set igmp groupmembership-interval <vlan_id> <2-3600>
VLAN Config
no set igmp groupmembership-interval
Interface Config
Global Config
no set igmp groupmembership-interval <vlan_id>
VLAN Config
10 seconds
set igmp maxresponse <1-3599>
Global Config
Interface Config
set igmp maxresponse <vlan_id> <1-3599>
VLAN Config
no set igmp maxresponse
Global Config
Interface Config
2 Switching Commands
IGMP Snooping Configuration Commands 99