Poe Disconnect-Mode Mode; Show Related Command; Show Poe Interfaces; Show Poe Powersupply - D-Link DES-7200 Cli Reference Manual

DES-7200 CLI Reference Guide
70.1.4

poe disconnect-mode mode

Use this command to set the disconnection detection mode. Use the no form of this
command to restore to the default value.
poe disconnect-mode mode
no poe disconnect-mode
Parameter
description
Command
mode
Examples

70.2 Show Related Command

There are the following POE showing commands:


show poe interfaces



show poe powersupply

70.2.1 show poe interfaces
Use this command to view the POE status on the interface.
show poe interfaces interface-id
Command
mode
Examples
Chapter 70 POE Management Configuration Commands
Parameter
mode
Global configuration mode.
Set the disconnect detection mode of the current POE system as dc:
DES-7210# configure
DES-7210(config)# poe disconnect-mode dc
DES-7210(config)# end
Privileged EXEC mode.
DES-7210# show poe interface gigabitethernet 0/2
Interface : Gi0/2
Port power enabled : ENABLE
Port connect status : OFF
Description
Disconnection detection mode, within the
range of [ac/dc]
70-5