Front Disc Brake Inspection; Inspect Brake Pad Lining; Inspect Brake Caliper Inner Parts; Cylinder Slide Bush - Suzuki Baleno Manual

Sy413, sy416, sy418

Hide thumbs Also See for Baleno:

Table of Contents

FRONT DISC BRAKE INSPECTION

Check pad lining for wear. When wear exceeds limit, replace with

Never polish pad lining with sandpaper. If lining is pol-

ished with sandpaper, hard particles of sandpaper will be

deposited in lining and may damage disc. When pad lin-

ing requires correction, replace it with a new one.

Pad thickness (lining + pad rim)

Standard : 15 mm (0.59 in.)

When pads are removed, visually inspect caliper for brake

fluid leak. Correct leaky point, if any.

Check slide bush for smooth movement as shown.

If it is found faulty, correct or replace. Apply rubber grease to bush

outer surface. Rubber grease should be the one whose viscosity

is less affected by such low temperature as –40_C (–40_F).

1. Apply rubber grease

Bush Dust Boot and Cylinder Boot

Check boots for breakage, crack and damage. If defective, re-

Excessive or uneven wear of pad lining may indicate unsmooth re-

turn of the piston. In such a case, replace rubber seal.

14 mm (0.55 in.)

: 6 mm (0.24 in.)

for ventilated disc

for solid disc

Show Quick Links

Table of Contents