Suzuki Baleno Manual page 762

7B1-78 AUTOMATIC TRANSMISSION
1. Shift lock solenoid assembly
2. Lock plate
DIFFERENTIAL SIDE OIL SEAL
REPLACEMENT
1) Lift up vehicle and drain transmission oil.
2) Remove drive shaft joints from differential gear of transmission.
3) Remove differential side oil seal by using screw driver or like.
4) Install new differential side oil seal by using special tool.
5) Install drive shaft referring to Section 4.
6) Refill A/T fluid referring to "CHANGING FLUID" in this section.
1. Differential side oil seal
2. Transmission case
SHIFT LOCK SOLENOID (if equipped)
1) Remove parking brake cover and console box.
2) Replace shift lock solenoid.
3) Install covers as they were.
Refer to Section 4 (DRIVE SHAFT) for procedure to disconnect
drive shaft joints.
For differential side oil seal removal, it is not necessary to re-
move drive shafts from steering knuckle.
NOTE:
For oil seal installation, press-fit oil seal so that transmis-
sion case end face is flush with oil seal end face.
Special Tool
(A): 09944-66020
NOTE:
Shift selector lever to "L" to facilitate work.
Check that detent pin is locked at "P" position by lock
plate.
Check to confirm that lock plate is pulled in when ignition
key is turned to "ON" and brake pedal is depressed, so
allowing detent pin to be pushed down.