Throttle Position Sensor Check - Suzuki Baleno Manual

Sy413, sy416, sy418
Hide thumbs Also See for Baleno:
Table of Contents

Advertisement

1. Solenoid valve wire coupler
2. Terminal for shift solenoid-A. (direct clutch solenoid)
3. Terminal for shift solenoid-B. (2nd brake solenoid)
4. 12 V battery
5. Shift solenoid-B. (2nd brake solenoid valve)
6. Shift solenoid-A. (Direct clutch solenoid valve)
3) Disconnect shift solenoid valve coupler from harness.
4) Apply 12 V to each terminal in solenoid valve coupler and check
to be sure that a click sound is heard from each of shift sole-
noid-A and -B.
If no click sound is heard, check lead wire and connections in
oil pan, and then replace applicable shift solenoid-A or B if wire
and connections are in good condition.
If click sound is heard from each of shift solenoids A and B, shift
solenoid electrical circuits are in good condition. Proceed to
"SHIFT SOLENOID VALVE CHECK" previously described in
this section.

THROTTLE POSITION SENSOR CHECK

Check throttle position sensor and its circuit referring to DTC
P0121 Flow Table in Section 6E1, 6E3, 6-1 or 6-2.
AUTOMATIC TRANSMISSION (3 A/T) 7B-45

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents