Suzuki Baleno Manual page 868

7C1-12 CLUTCH (HYDRAULIC TYPE)
1. Reservoir cap 6. Circlip
2. Cylinder 7. Boot
3. Piston assembly 8. Lock nut
4. Push rod 9. Clevis
5. Piston stopper
UNIT REPAIR OVERHAUL
CLUTCH MASTER CYLINDER
DISASSEMBLY
1) Remove boot and then circlip with piston pushed in.
1. Circlip
2. Push rod
2) Blow compressed air gradually into hole for pipe connection to
remove piston assembly, using care to prevent it from jumping
out.
1. Piston
2. Cylinder
INSPECTION
Inspect all disassembled parts for wear or damage, and replace
parts if necessary.
NOTE:
D Wash disassembled parts with brake fluid.
D Do not reuse piston assembly and circlip.
Inspect cylinder bore for scoring or corrosion.
It is best to replace corroded cylinder. Corrosion can be identified
as pits or excessive roughness.
NOTE:
Polishing bore of cylinder with cast aluminum body with any-
thing abrasive is prohibited, as damage to cylinder bore may
occur.
Rinse cylinder in clean brake fluid. Shake excess rinsing fluid from
cylinder. Do not use a cloth to dry cylinder, as lint from cloth cannot
be kept away from cylinder bore surfaces.