1. No.2 bearing
2. Puller
Inspection and reassembly
1) Check tooth surface of gear and rotation of bearing and replace
with new one if necessary
As long as no abnormal condition such as noise exists before
removal, replacement is unnecessary.
2) Drive in No.2 bearing by using special tools and hammer.
Special Tool
(A): 09913-84510
(B): 09926-58010
1. No.2 bearing
3) Drive in No.1 bearing by using special tool and hammer.
Special Tool
(A): 09913-80112
1. No.1 bearing
Output Shaft
1) Drive out No.2 bearing by using puller and press.
2) Remove snap ring by using screw drivers.
1. Snap ring
2. Screw drivers
3. No.1 bearing
MANUAL TRANSMISSION 7A2-25