Front
A / T
Front
<J18 engine model>
For remounting, reverse dismounting procedure. Use the following
specified torques and note points listed below.
Tightening Torque
.
(a): 90 N
m (9.0 kg-m, 65.0 lb-ft)
.
(b): 19 N
m (1.9 kg-m, 14.0 lb-ft)
.
(c): 28 N
m (2.8 kg-m, 20.5 lb-ft)
.
(d): 60 N
m (6.0 kg-m, 43.5 lb-ft)
.
(f): 55 N
m (5.5 kg-m, 40.0 lb-ft)
.
(g): 45 N
m (4.5 kg-m, 32.5 lb-ft)
Push in each drive shaft joint fully so that snap ring engages with
differential gear and center shaft respectively.
CAUTION:
Care should be taken not to scratch oil seal lip with
drive shaft while inserting drive shaft joint into
transmission.
Do not hit drive shaft joint with hammer when instal-
ling it.
Set each clamp for wiring securely.
Adjust select cable.
Refill fluid and adjust its level at normal operating temperature.
Check to make sure that engine and transmission function prop-
erly.
Make sure that these is no evidence of fluid leakage.
AUTOMATIC TRANSMISSION 7B1-87