Suzuki Baleno Manual page 191

1. Junction/fuse block
1. Yellow connector (for air bag)
2. White connector (for auto cruise)
1. Steering column lower cover
2. Key cylinder
1. Hole cover
3) Connect three connectors for contact coil and combination
switch wire harness to junction/fuse block.
4) Connect yellow connector (for air bag) and white 4-P connec-
tor (for auto cruise, optional).
5) Tighten clamp and band for contact coil and combination
switch wire harness.
3. Band
4. Clamp
6) Install lower cover to key cylinder.
7) Tighten steering column lower cover screws, and then install
upper cover to lower cover.
8) Install hole cover.
9) Install steering wheel to its shaft. Refer to "STEERING
WHEEL" earlier in this section.
10) Connect battery negative cable.
11) Enable air bag system. Refer to "Enabling Air Bag System" un-
der "Service Precautions" earlier in this section.
AIR BAG STEERING WHEEL AND COLUMN 3C1-13