Suzuki Baleno Manual page 605

TABLE A-2 GEAR CHANGE FAILURE
STEP
1 Was "AUTOMATIC TRANSMISSION DIAGNOSTIC
FLOW TABLE" performed?
2 Disconnect solenoid valve wire coupler and perform manu-
al road test.
Is upshift from 1st to 2nd possible?
3 Is upshift from 2nd to 3rd possible?
TABLE A-3 EXCESSIVE SHOCK AT RANGE SELECTION OR GEAR CHANGE
STEP
1 Was "AUTOMATIC TRANSMISSION DIAGNOSTIC
FLOW TABLE" performed?
2 Is line pressure proper?
3 Does excessive shock occur when selecting "D" range
from "N" range?
4 Does excessive shock occur when selecting "R" range
from "N" range?
5 Does excessive shock occur at 1st to 2nd gear change?
ACTION
ACTION
AUTOMATIC TRANSMISSION (3 A/T) 7B-35
YES
Go to Step 2. Go to "AUTOMATIC
TRANSMISSION
DIAGNOSTIC FLOW
TABLE".
Go to Step 3. 1-2 shift valve sticks
or Shift solenoid-B
(2nd brake solenoid)
valve sticks.
Gear shift control 2-3 shift valve sticks
system defective. or Shift solenoid-A
Go to A / T Diagnostic (Direct clutch sole-
Flow Table B. noid) valve sticks.
YES
Go to Step 2. Go to "AUTOMATIC
TRANSMISSION
DIAGNOSTIC FLOW
TABLE".
Go to Step 3. Regulator valve
defective, Throttle
valve defective or
Accelerator cable
maladjusted.
Forward clutch Go to Step 4.
accumulator opera-
tion failure, Forward
clutch worn or
Forward clutch oil
circuit check ball
operation failure.
1st-Reverse brake Go to Step 5.
worn, 1st-Reverse
brake oil circuit check
ball operation failure.
2nd brake accumula- In case of excessive
tor defective, 2nd shock at 2nd to 3rd
brake worn, 2nd gear change, Direct
brake oil circuit check clutch worn or Direct
ball operation failure. clutch oil circuit check
ball operation failure.
NO
NO