Suzuki Baleno Manual page 474

7A-18 MANUAL TRANSMISSION (G13 AND G16 ENGINE MODELS)
1. Gear shift & select shaft
1. Left case 3. Transmission case bolt
2. Right case 4. Reverse shaft bolt
1. 5th & REV gear shift shaft
2. 5th & REV gear shift guide shaft
3. Gear shift yoke
4. Reverse gear shaft
5. Washer
6. Reverse idler gear
1. Right case
2. Low speed gear shift shaft
3. High speed gear shift shaft
4. Countershaft assembly
5. Input shaft assembly
7) Pull out gear shift & select shaft assembly.
8) Remove reverse shaft bolt with washer.
9) Remove 11 case bolts from outside and another 2 from clutch
housing side.
10) Tapping left case flanges with plastic hammer, remove left
case.
11) Remove gear shift yoke.
12) Pull out reverse gear shaft with washer, then take off reverse
idler gear.
13) Pull out 5th & REV gear shift guide shaft together with 5th &
REV gear shift shaft.
NOTE:
When removing 5th & REV gear shift shaft and guide
shaft, push up high speed gear shift shaft and shift it to
4th to facilitate removal of 5th & REV shifter.
14) Tapping input shaft end with plastic hammer, push it out as as-
sembly from case a little, then take out input shaft assembly,
counter shaft assembly, high speed gear shift shaft and low
speed gear shift shaft all at once.
15) Remove countershaft L bearing cup from left case.
16) Remove differential side L oil seal also from left case.