Suzuki Baleno Manual page 909

8-12 BODY ELECTRICAL SYSTEM
SEAT BELT WARNING LIGHT/BUZZER (if equipped)
DESCRIPTION OF CIRCUIT
The seat belt warning light/buzzer circuit is a system to light and sound the light and buzzer respectively for several
seconds, urging the driver to wear his seat belt. After several seconds, the light goes OFF and the buzzer stops
sounding whether the seat belt is worn or not.
INSPECTION
When warning light/buzzer fails to make lighting/sounding, use
above circuit diagram as reference to check bulb, buzzer, wiring,
etc.
INSPECTION OF WARNING CONTROLLER
Connect negative (–) terminal of battery to terminals "15" and "17"
of controller and positive (+) terminal of battery to terminals "16"
and "20" of controller and check that buzzer emits buzzing sound
for 4 – 8 seconds. Also, it should operate likewise when terminals
are disconnected and reconnected. If check result is not satisfacto-
ry, replace.
1. Battery
2. Main fuse
3. Ignition switch
4. Junction box
5. Seat belt warning light
6. Warning controller/buzzer
7. Seat belt switch
8. Joint connector