Transmission Range Sensor - Suzuki Baleno Manual

Sy413, sy416, sy418
Hide thumbs Also See for Baleno:
Table of Contents

Advertisement

7B-58 AUTOMATIC TRANSMISSION (3 A/T)

1. Transmission range sensor

2. Select cable
3. Manual shift lever
4. Manual select
cable joint
1. Manual select
cable joint
A: Align with cable joint
B: Tighten with wrench
1. Transmission range sensor
2. Transmission range sensor joint
ADJUSTMENT
1) Before tightening cable end nut, shift selector lever to N range.
2) Also shift manual shift lever to N range.
NOTE:
Make sure that nut and cable joint have clearance under
above conditions.
3) Turn nut A by hand till it contacts manual select cable joint. Then
tighten nut B with wrench.
4) After select cable was installed, check for the following.
D Push vehicle with selector lever shifted to P range. Vehicle
should not move.
D Vehicle can not be driven in N range.
D Vehicle can be driven in D, 2 and L ranges.
D Vehicle can be backed in R range.
TRANSMISSION RANGE SENSOR
(SHIFT SWITCH)
REMOVAL
1) Disconnect transmission range sensor coupler.
2) Remove transmission range sensor from transmission.
CAUTION:
Do not overhaul transmission range sensor.
INSTALLATION
1) Shift manual shift lever to N range, that is, to shift selector lever
to N range.
1. Select cable
2. Manual shift lever
2) Using flat tip screwdriver, turn transmission range sensor joint
clockwise or counterclockwise to the position shown in figure
and check that a "click" is heard from joint at this position.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents