Suzuki Baleno Manual page 216

1. Hole of inside oil seal (Wheel speed sensor
installation hole in knuckle)
2. Projection on knuckle
Inside Oil Seal
With hole in inside oil seal matched with projection on knuckle (for
vehicle without ABS) or wheel speed sensor installation hole in
knuckle (for vehicle with ABS), drive in Oil seal until its stepped sur-
face contacts knuckle by using special tools (C) and (E).
NOTE:
When driving in oil seal, be careful not to deform or tilt it or not
to cause damage to rubber part.
Special Tools
(C): 09924-74510
(E): 09944-66010
1. Inside oil
seal
2. Knuckle
3. Grease
Outside Oil Seal
1. Outside oil
seal
Drive in oil seal until its end contacts with snap ring using special
2. Knuckle
tools (C) and (E). As for its installing direction, refer to left figure.
3. Grease
Special Tools
(C): 09924-74510
(E): 09944-66010
FRONT SUSPENSION 3D-17