Suzuki Baleno Manual page 763

1. Interlock cable
2. Screw
3. Release shaft
1. Cable bracket nut
2. Key release cam
3. Cable end
4. Cam boss
1. Interlock cable
2. Clamp
INTERLOCK CABLE (if equipped)
NOTE:
Don't bend interlock cable excessively when removing and
installing it, or system will not operate correctly.
REMOVAL
1) Disconnect negative cable at battery and disable air bag sys-
tem, referring to "DISABLING AIR BAG SYSTEM" in Section 9J.
2) Remove steering column hole cover and steering joint cover.
3) Disconnect steering shaft upper joint bolt and steering column
mounting bolts and nuts.
CAUTION:
Steering column mounting bolts and/or nuts should
not be loosened with steering shaft joint upper side
tightened as this could cause damage to shaft joint
bearing.
4) Remove steering upper cover.
5) Remove interlock cable clamp screw located at ignition switch
and disconnect interlock cable from release shaft with ignition
switch turned at "ACC" position. And then turn ignition switch to
"LOCK" position.
6) Remove parking brake cover and console box.
7) Remove cable bracket nut and detach cable end from key re-
lease cam while pressing claws of release cam boss.
At this time, be careful not to cause damage to its claws.
8) Remove interlock cable.
INSTALLATION
1) Install interlock cable as shown in figure.
2) Connect cable end to steering lock and tighten cable clamp
screw securely.
AUTOMATIC TRANSMISSION 7B1-79