Suzuki Baleno Manual page 403

5-78 BRAKES
1. Steering column
2. Push rod clevis
3. Brake pedal arm
[1.8L engine RH model]
1) Install booster to dash panel as shown. Then connect booster
2) Torque booster attaching nuts to specification.
4. Clevis pin
5. Cotter pin
6. Nut
3) Connect booster vacuum hose to booster.
4) Install throttle body. Refer to "THROTTLE BODY AND INTAKE
5) Install power steering pump high pressure hose to power steer-
6) Fill power steering fluid reservoir with specified fluid. Refer to
7) Install master cylinder, referring to "MASTER CYLINDER RE-
1. Master cylinder
8) After installing, check pedal height and play.
2. Brake pipe
3. Reservoir tank
9) After all service works are done, start engine and check that
4. Flare nut
5. Master cylinder
attaching nut
push rod clevis to pedal arm with clevis pin and cotter pin.
Tightening torque
(a): 13 N·m (1.3 kg-m, 9.5 lb-ft)
MANIFOLD" in Section 6A3.
ing pump.
Section 3B1. Also follow "AIR BLEEDING PROCEDURE" in
Section 3B1.
PAIR" in this section.
Tighten Torque
(a): 13 N·m (1.3 kg-m, 9.0 lb-ft)
(b): 16 N·m (1.6kg-m, 12.0 lb-ft)
there exists no leakage around power steering system.