Remove And Install Rear Brake Hose/Pipe - Suzuki Baleno Manual

REMOVE AND INSTALL REAR BRAKE HOSE/PIPE

1) Raise, suitably support vehicle and remove wheel if necessary.
2) Clean dirt and foreign material from both hose ends or pipe end fittings. Remove brake hose or pipe.
3) Install it by reversing removal procedure, noting the following points.
D Install clamps properly referring to figure below.
D Never reuse pipe cover (protector) nut once removed. Be sure to use a new one.
D When installing hose, make sure that it has no twist or kink.
D Fill and maintain brake fluid level in reservoir and bleed brake system.
[For vehicles without LSPV]
TOP
SIDE
REAR SIDE
LEFT SIDE
CLAMP: J CLAMP: K
LEFT SIDE
TOP SIDE
DETAIL: L
Front
TOP
SIDE
Good
Clamp K
For 4 door vehicle
For 3 door vehicle
Clamp J
Tightening Torque
(a): 10 N
Tightening torque for g g q
brake pipe flare nuts
BRAKES 5-29
NG
Clamp K
1. To P (Proportioning) valve
2. Pipe cover
3. Clamp
4. 4-way joint
5. E-ring
6. Flexible hose
.
m (1.0 kg-m, 7.5 lb-ft)
.
N m kg-m lb-ft
16 1.6 11.5