Contact Coil And Combination Switch Assembly; Air Bag Wire Harness And Connectors; Disposal Precautions - Suzuki Baleno Manual

3C1-6 AIR BAG STEERING WHEEL AND COLUMN

1. Contact coil and combination switch assembly

2. To horn
3. Connector to driver air bag (inflator) module
4. Connector to air bag wire harness
1. Air bag wire harness
2. Ground
3. SDM case ground
Contact Coil and Combination Switch Assembly
Do not turn contact coil (on combination switch) more than allow-
able number of turns (about two and a half turns from the center
positIon clockwise or counterclockwise respectively), or coil will
break.

Air Bag Wire Harness and Connectors

CAUTION:
When an open in air bag wire harness, damaged wire har-
ness, connector or terminal is found, replace wire har-
ness, connectors and terminals as an assembly.
D Air bag wire harness can be identified easily as it is covered with
a yellow protection tube. Be very careful when handling it.
D When installing it, be careful so that the air bag wire harness is
not caught or does not interfere with other parts.
D Make sure all air bag system grounding points are clean and
grounds are securely fastened for optimum metal-to metal con-
tact. Poor grounding can cause intermittent problems that are
difficult to diagnose.

DISPOSAL PRECAUTIONS

Do not dispose of live (undeployed) air bag (inflator) modules (driv-
er and passenger). When disposal is necessary, be sure to deploy
it first according to the procedure described in SECTION 9J and
then dispose it. Refer to SECTION 9J for disposal procedure.
WARNING:
Failure to follow proper air bag (inflator) module disposal
procedures can result in air bag deployment which could
cause personal injury. Undeployed air bag (inflator) mod-
ules must not be disposed of through normal refuse
channels. The undeployed air bag (inflator) module con-
tains substances that can cause severe illness or per-
sonal injury if the sealed container is damaged during
disposal.