Automatic Transmission Basic Check - Suzuki Baleno Manual

AUTOMATIC TRANSMISSION BASIC CHECK

This check very important for troubleshooting when TCM and ECM has detected no malfunction DTC and no ab-
normality has been found in visual inspection. Follow the flow table carefully.
STEP
1 Was "A/T DIAGNOSTIC FLOW TABLE" performed?
2 Check A/T Fluid.
Warm transmission to normal operating temperature
and check fluid level and contamination referring to
"Fluid Level Check" in this section.
Is it in good condition?
3 Check Select Cable for Adjustment referring to
"SELECT CABLE ADJUSTMENT" in this section.
Is it adjusted correctly?
4 Check Transmission Range Sensor Circuit for Opera-
tion referring to "TRANSMISSION RANGE SENSOR
CIRCUIT CHECK" in this section.
Is check result satisfactory?
5 Check Engine Idle Speed referring to "IDLE
SPEED/ IAC DUTY INSPECTION" in Section 6E1, 6E2,
6E3 or 6E4.
Is it specified speed?
6 Perform Manual Road Test referring to "MANUAL
ROAD TEST" in this section.
Is check result satisfactory?
7 Perform Engine Brake Test referring to "ENGINE
BRAKE TEST" in this section.
Is check result satisfactory?
8 Perform "P" Range Test referring to ""P" RANGE TEST"
in this section.
Is check result satisfactory?
9 Perform "TIME LAG TEST", "STALL TEST" and "LINE
PRESSURE TEST" referring to each applicable item in
this section.
Are all check results satisfactory?
ACTION
AUTOMATIC TRANSMISSION 7B1-31
YES
Go to Step 2. Go to "A / T DIAG-
NOSTIC FLOW
TABLE".
Go to Step 3 Add or change fluid.
Go to Step 4. Adjust.
Go to Step 5. Go to Step 3 of DTC
P0705 Flow Table.
Go to Step 6. Inspect idle air control
system referring to
Section 6E1, 6E3, 6-1
or 6-2.
Go to Step 7. Go to Step 9.
Go to Step 8. Go to "TROUBLE
DIAGNOSIS
TABLE-3" in this sec-
tion.
Go to "TROUBLE Parking lock pawl
DIAGNOSIS and / or spring
TABLE-1, -2 AND -3" malfunction.
in that order.
Go to "TROUBLE Repair or replace
DIAGNOSIS malfunction parts.
TABLE-2" and then
"TROUBLE DIAGNO-
SIS TABLE-3".
NO