Suzuki Baleno Manual page 506

7A1-8 MANUAL TRANSMISSION (J18 ENGINE MODEL)
1. Transmission case bolt
2. Reverse shaft bolt
1. Input R bearing
2. Plate
3. Bolt
1. Input R bearing
1. Input shaft oil seal
2. Countershaft R bearing cup
MAIN SHAFT AND COUNTERSHAFT
1) For removal procedure, refer to Steps 3), 6) and 8) of Gear Shift-
er, Main Shaft and Countershaft of Disassembling Unit in SEC-
TION 7A.
2) Remove transmission case outside bolts and clutch housing
bolts.
3) For removal procedure, refer to Steps 10) and 12) to 16) of Gear
Shifter, Main Shaft and Countershaft of Disassembling Unit in
SECTION 7A.
RIGHT CASE
1) Remove input R bearing stopper bolt and plate.
2) Remove input R bearing by using special tools.
Special Tool
(A): 09930-30104
(B): 09923-74510
3) Remove input shaft oil seal by using special tools (combination
of bearing remover and sliding shaft).
Special Tool
(A): 09930-30104
(B): 09923-74510
4) Also pull out countershaft R bearing cup by using bearing re-
mover 09941-64511 with sliding shaft 09930-30104.