Code No.31 Actuator Circuit - Suzuki Baleno Manual

CODE NO.31 ACTUATOR CIRCUIT

(ACTUATOR CIRCUIT OPEN OR SHORTED GROUND)
1 Disconnect suspension control module coupler with
ignition switch OFF.
2. Check resistance between the following each two
terminals.
TERMINALS
Between A2 and A4
Between A2 and A12
Between A4 and A12
Between A3 and A5
Between A3 and A6
Between A5 and A6
3. Is specified resistance obtained?
NO
Check absorber adjusting actuators, referring to "AB-
SORBER ADJUSTING ACTUATOR" in this section.
Are they OK?
YES
Open actuator wire harness.
RESISTANCE
2.3 – 7.0 W
SUSPENSION CONTROL SYSTEM 3G-17
Terminal arrangement of suspension control module coupler
(Viewed from harness side)
1. Disconnected suspension control module coupler
2. Ohmmeter
Actuator wire shorted to ground circuit or poor sus-
pension control module coupler connection.
If wire harnesses and connections are OK, intermit-
tent trouble or faulty suspension control module. Re-
fer to "Intermittent trouble" in Section 0A.
Faulty actuator(s).
1. Suspension control module
2. Front left actuator
3. Front right actuator
4. Rear left actuator
5. Rear right actuator
YES
NO