Remove And Install Front Brake Hose/Pipe - Suzuki Baleno Manual

REMOVE AND INSTALL FRONT BRAKE HOSE/PIPE

1) Raise, suitably support vehicle and remove wheel if necessary.
2) Clean dirt and foreign material from both hose ends or pipe end fittings. Remove brake hose or pipe.
3) Install it by reversing removal procedure, noting the following points.
For installation, make sure that steering wheel is in straightforward position and hose has no twist or kink.
Check to make sure that hose doesn't contact any part of suspension, both in extreme right and extreme left
turn conditions. If it does at any point, remove and correct. Fill and maintain brake fluid level in reservoir. Bleed
brake system.
[For left-hand steering vehicles without ABS]
Clamp E
[For left-hand steering vehicles with ABS]
Clamp E
BRAKE HOSE/PIPE
Clamp D
Front
Clamp D
Front
TOP SIDE
FRONT SIDE
Clamp D
Clamp F
TOP SIDE
FRONT SIDE
Clamp F
Clamp I
Tightening torque for g g q
brake pipe flare nuts
BRAKES 5-27
TOP SIDE
FRONT SIDE
CLAMP: D CLAMP: F
TOP SIDE
LEFT SIDE
CLAMP: E CLAMP: I
1. Master cylinder
2. P (Proportioning) valve (shown)
or 6-way joint (for vehicles with LSPV,
not shown)
3. ABS hydraulic unit (if equipped)
4. E-ring
5. Flexible hose
6. Brake caliper
7. Clamp
8. 4-way joint (for vehicles with LSPV)
or P (Proportioning) valve
Tightening Torque
.
(a): 10 N m (1.0 kg-m, 7.5 lb-ft)
.
(b): 23 N m (2.3 kg-m, 17.0 lb-ft)
.
N m kg-m
16 1.6
lb-ft
11.5