Rear Differential Oil Inspection And Change; Automatic Transmission; Fluid Level Inspection; Fluid Change - Suzuki Baleno Manual

1. Oil level/filler plug
2. Drain plug
4-speed A/T
3-speed A/T
1. Oil level gauge 4. FULL COLD mark
2. FULL HOT mark 5. LOW COLD mark
3. LOW HOT mark
4-speed A/T 3-speed A/T
ITEM 6-7

Rear Differential Oil Inspection and Change

(4WD vehicle only)
[Inspection]
1) Inspect rear differential case for evidence of oil leakage.
Repair leaky point, if any.
2) Make sure that the vehicle is placed level for oil level check.
3) Remove level plug of differential. Oil level can be checked
roughly by means of level plug hole.
That is, if oil flows out of level plug hole or if oil level is found up
to hole when level plug is removed, oil is properly filled.
If oil is found insufficient, pour specified amount of specified oil
as given in SECTION 7F.
4) Apply sealant to plug thread and tighten it to specified torque.
[Change]
Place the vehicle level and drain oil by removing drain plug. Pour
specified amount of specified oil, apply sealant to each plug thread
and tighten drain plug and filler plug to specified torque, referring
to ON-VEHICLE SERVICE in SECTION 7F.
ITEM 6-8

Automatic Transmission

[Fluid level inspection]

1) Inspect transmission case for evidence of fluid leakage.
Repair leaky point, if any.
2) Make sure that vehicle is placed level for fluid level check.
3) Check fluid level.
For fluid level checking procedure, refer to ON-VEHICLE SER-
VICE in SECTION 7B or 7B1 and be sure to perform it under
specified conditions. If the lowest fluid level (6) is lower than
LOW HOT mark, replenish specified fluid.

[Fluid change]

1) Perform steps 1) and 2) of above Fluid Level inspection.
2) Change fluid. For its procedure, refer to ON-VEHICLE SER-
VICE in SECTION 7B or 7B1.
CAUTION:
Use of specified fluid is absolutely necessary.
1. Drain plug
MAINTENANCE AND LUBRICATION 0B-17