Circuit Breaker - Suzuki Baleno Manual

1. Sliding roof drive gear assembly coupler
1. Sliding roof drive gear assembly coupler
1. Sliding roof drive gear assembly coupler

CIRCUIT BREAKER

NOTE:
This inspection must be done with the complete sliding roof
assembly installed of the vehicle.
1) Disconnect coupler from sliding roof drive gear assembly.
2) Connect (–) Battery lead terminal C2, (+) battery lead to termi-
nal C1, then open sliding roof completely.
3) Disconnect (–) battery lead from terminal C2.
4) Connect ammeter between terminal C1 and (+) battery lead.
5) Measure time that the current falling down around 16A – 23A to
0A when (–) battery lead connected terminal C2 again.
Standard measured time: 10 – 60 sec.
If measured time is out of specification, replace sliding roof drive
gear assembly.
6) When the current reaches 0A, disconnect both terminal C2 and
C1 from battery lead.
7) 60 seconds after the disconnection of terminal C2 and C1, con-
nect (+) battery lead to terminal C2, (–) battery lead to terminal
C1 and check that the sliding roof operates to closing direction.
BODY ELECTRICAL SYSTEM 8-47