Suzuki Baleno Manual page 468

7A-12 MANUAL TRANSMISSION (G13 AND G16 ENGINE MODELS)
1. Instrument panel
2. Heater control panel
3. Control lever housing nut
4. Control lever boot
5. Control lever knob
1. VSS
2. O-ring 3. Driven gear
2) Apply thread lock cement and then install knob to control lever.
Make sure that knob is aligned with lever.
3) Install control lever assembly and related parts as they were.
For positioning control lever, loosely install 4 guide plate bolts
and 4 control lever housing nuts first, adjust position and then
tighten those nuts and bolts.
NOTE:
D Do not apply grease to extension rod bush of transmis-
sion end.
D Apply grease to gear shift control shaft bushes.
D Make sure that boots are installed correctly.
Distance "a": 137 mm (5.4 in.)
VEHICLE SPEED SENSOR
(VSS, SPEEDOMETER DRIVEN GEAR)
REMOVAL
1) Disconnect negative cable at battery.
2) Disconnect VSS coupler.
1. VSS
2. M/T
3) Remove VSS.