Suzuki Baleno Manual page 476

7A-20 MANUAL TRANSMISSION (G13 AND G16 ENGINE MODELS)
1. Reverse gear shift lever
2. Input shaft oil seal
3. Countershaft R bearing cup
1. Gear shift shaft oil seal
SUB ASSEMBLY SERVICE
RIGHT CASE
1) If reverse gear shift lever has been removed, fasten it with 2
bolts after applying thread lock cement.
Tightening Torque
(a): 23 N·m (2.3 kg-m, 17.0 lb-ft)
NOTE:
D When installing reverse gear shift lever, set distance "a"
between lever end and shaft bore to be 5 mm (0.2 in.).
Distance "a": 5 mm (0.2 in.)
D Distance "a" can be measured by installing reverse gear
shaft provisionally.
D When "a" is 5 mm (0.2 in.), clearance between reverse
idler gear groove and shift lever end will be 1 mm (0.04
in.).
2) Install input shaft oil seal facing its spring side upward. Use spe-
cial tool and hammer for installation and apply grease to oil seal
lip.
"B": SUZUKI SUPER GREASE A, 99000-25010
Special Tool
(A): 09951-76010
3) Install countershaft R bearing cup by using special tools and
hammer.
Special Tool
(B): 09924-74510
(C): 09925-68210
4) Apply grease to gear shift shaft oil seal at its lip and install it up
to bottom of the bore by using special tool and hammer.
"B": SUZUKI SUPER GREASE A, 99000-25010
Special Tool
(D): 09925-58210