Suzuki Baleno Manual page 371

5-46 BRAKES
1. Brake shoe
2. Shoe hold down spring
3. Parking brake shoe lever
INSTALLATION
NOTE:
See NOTE at the beginning of this section.
1) Before installing brake drum, to maximize brake shoe-to-drum
clearance, put screwdriver between rod and ratchet and push
down ratchet as shown in figure.
1. Rod
2. Ratchet
NOTE:
1. Rod
2. Ratchet
The figure show ratchet position where brake shoe-to-
drum clearance is maximum.
2) Put brake shoe hold down spring back to its original position as
shown. (Put shoe hold down spring in place by moving shoe le-
ver so that shoe lever comes to the side of shoe hold down
spring.)
3) Install brake drum after making sure that inside of brake drum
and brake shoes are free from dirt and oil.
4) Tighten brake drum screws.
5) Upon completion of all jobs, depress brake pedal with about 30
kg (66 lbs) load three to five times so as to obtain proper drum-
to-shoe clearance.
Adjust parking brake cable.
6) Install parking brake lever cover.
7) Install wheel and tighten wheel nuts to specified torque.
Tightening Torque
.
(a): 85 N
8) Check to ensure that brake drum is free from dragging and
proper braking is obtained. Then remove vehicle from hoist and
perform brake test (foot brake and parking brake).
m (8.5 kg-m, 61.5 lb-ft)