Suzuki Baleno Manual page 543

1. High speed gear shift yoke ass'y
2. Low/high speed fork bolt
3. Low speed gear shift yoke ass'y
4. Gear shift No.2 cam
5. Pin
6. No.2 cam return spring
7. Pin
8. Low speed gear shift fork
9. Low/high speed fork bolt
1. Fifth/reverse gear shift yoke
2. Ball
3. Fifth/reverse gear
shift guide shaft
4. Reverse gear shift arm
3) Disassemble component parts by using spring pin remover and
hammer.
Special Tool
(A): 09922-85811 (4.5 mm)
4) Assemble shift shafts as shown while making sure that compo-
nent parts are in proper order.
NOTE:
D Correct shaft surface by using oil stone, if any scratch or
dent is found.
D Support shaft with wood blocks when driving in spring
pins.
Tightening Torque
(a): 10 N·m (1.0 kg-m, 7.5 lb-ft)
5th & REV Gear Shifter
1) Disassemble component parts by using spring pin remover and
hammer.
Special Tool
(A): 09922-85811 (4.5 mm)
2) Replace or correct parts as required and assemble shafts mak-
ing sure that component parts are in proper order as shown.
NOTE:
Install 2 steel balls in reverse gear shift arm without fail.
5. Snap ring
6. Pin
7. Ball
8. Reverse gear
shift arm spring
MANUAL TRANSMISSION 7A2-21