Oil Pan Gasket - Suzuki Baleno Manual

1. Oil pan
2. Wood block
1. Oil pan
2. Oil cleaner magnet

OIL PAN GASKET

REMOVAL
1) Raise vehicle and drain transmission fluid.
2) Remove oil pan from transmission.
After removing oil pan bolts, tap around oil pan lightly with a
plastic hammer for removal.
CAUTION:
D Never hammer oil pan hard, or it may get deformed.
It is recommended to hit oil pan indirectly through
wood block.
D Do not force oil pan off by using a flat tip screwdriv-
er or the like as it may cause damage to gasketed
surface.
3) Remove gasket on mating surface thoroughly.
INSTALLATION
For oil pan installation, reverse its removal procedure using care
for the following.
1) Make sure to use new gasket.
2) Clean inside of oil pan before installation.
3) Clean oil cleaner magnet and install it in the position right below
oil strainer.
4) There are 15 oil pan securing bolts in all and two of them have
1. Cross slotted
bolts
cross slot in their heads.
Mount these cross slotted bolts in such positions as shown in
figure after applying sealant to their threads. However, do not
apply sealant to other 13 bolts.
CAUTION:
Do not use sealant to gasket surface.
"A": SUZUKI BOND No.1215, 99000-31110
AUTOMATIC TRANSMISSION (3 A/T) 7B-49