Suzuki Baleno Manual page 776

7B1-92 AUTOMATIC TRANSMISSION
1. Throttle pressure con-
trol solenoid
2. No.1 shift solenoid
3. No.2 shift solenoid
4. TCC control solenoid
5. Valve body assembly
15) Release solenoid wiring harness from clamp.
16) Disconnect pressure control, No.1 shift, No.2 shift and lock up
17) Remove valve body assembly by removing eight bolts.
18) Remove solenoid coupler mounting bolt and remove solenoid
6. 20 mm (0.78 in.)
7. 50 mm (1.97 in.)
8. 55 mm (2.17 in.)
9. Transmission
temperature sensor
19) Remove 2 gaskets.
1. Gasket
20) Remove snap ring using special tool.
21) Pull out 2nd and 4th brake cover with O-ring by using plier or
1. Snap ring
2. Brake cover
22) Inspect 2nd and 4th brake piston rod stroke.
control solenoid couplers.
NOTE:
Each bolt length is indicated in figure.
CAUTION:
Be careful not to let manual valve fall off when re-
moving valve body assembly.
coupler and its harness.
Then remove transmission temperature sensor and its har-
ness from clamps.
NOTE:
Never reuse removed gaskets.
Special Tool
(A): 09900-06108
the like.
a) Set dial gauge and magnetic stand (special tools).
Special Tool
(A): 09900-20606
(B): 09900-20701