Suzuki Baleno Manual page 174

1. Steering column
2. Steering lock
1. Steering column 2. Steering shaft
STEERING WHEEL AND COLUMN (NOT EQUIPPED WITH AIR BAG) 3C-13
STEERING LOCK (IGNITION SWITCH)
REMOVAL
1) Disconnect negative battery cable.
2) Remove steering column. Refer to "STEERING COLUMN" ear-
lier in this section.
3) Using center punch as shown, loosen and remove steering lock
1. Center punch
(with sharp point)
mounting bolts.
2. Steering lock
mounting bolts
NOTE:
Use care not to damage aluminum part of steering lock
body with center punch.
4) Turn ignition key to "ACC" or "ON" position and remove steering
lock assembly from steering column.
INSTALLATION
1) Position oblong hole of steering shaft in the center of hole in col-
umn.
2) Turn ignition key to "ACC" or "ON" position and install steering
lock assembly onto column.
3) Now turn ignition key to "LOCK" position and pull it out.
4) Align hub on lock with oblong hole of steering shaft and rotate
shaft to assure that steering shaft is locked.
5) Tighten two new bolts until head of each bolt is broken off.
6) Turn ignition key to "ACC" or "ON" position and check to be sure
that steering shaft rotates smoothly. Also check for lock opera-
tion.
7) Install steering column. Refer to "STEERING COLUMN" earlier
in this section.
8) Connect negative battery cable.