Important Starter Functions - Siemens Sinamics S110 Function Manual

3.2.1

Important STARTER functions

STARTER supports the following tools for managing the project:
● Copy RAM to ROM
● Download to target device
● Load to PG/PC
● Restoring the factory settings
● Commissioning wizard
● Displaying toolbars
Copy RAM to ROM
You can use this function to save volatile Control Unit data to the non-volatile memory. This
ensures that the data is still available after the 24 V Control Unit supply has been switched
off.
This function can be activated as follows:
● Tools → Setting → Download → Activate "Copy RAM to ROM"
● Right-click Drive unit → Target device → Copy RAM to ROM
● Drive unit grayed out → "Copy RAM to ROM" button
Download to target device
You can use this function to load the current STARTER project to the Control Unit. First of
all, a consistency check is performed on the project, with messages triggered if any
inconsistencies are detected. You will need to rectify any inconsistencies before performing
a download. If no inconsistencies are detected, the data is loaded to the work memory of the
Control Unit. A reset is then triggered.
This function can be activated as follows:
● Right-click Drive unit → Target device → Download to target device
● Drive unit grayed out → Download to target device button
● Online/offline comparison screen → Download to target device button
● Project to all drive units simultaneously:
Function Manual
Function Manual, 01/2011, 6SL3097-4AB10-0BP3
This means that every time data is loaded to the target system by choosing "Load project
to target system", the data is stored in the non-volatile memory.
NOTICE
You may only switch off the power supply to the Control Unit after saving has finished;
i.e. after saving has started, wait until it has finished and parameter p0977 has the value
0 once more.
Load project to target system button, Project → Download to target device menu
Commissioning with PROFIBUS
3.2 STARTER commissioning tool
47