Fault And Alarm Messages; General Information About Faults And Alarms - Siemens Sinamics S110 Function Manual

Hide thumbs Also See for Sinamics S110:

Table of Contents

Fault and alarm messages

The errors and states detected by the individual components of the drive system are

indicated by messages.

The messages are categorized into faults and alarms.

The individual faults and alarms are described in the SINAMICS S110 List Manual in the

section titled "Faults and Alarms". Here you can also find a chapter titled "Function

diagrams" → "Faults and alarms", which contains function diagrams for the fault buffer, alarm

buffer, fault trigger, and fault configuration.

Properties of faults and alarms

Function Manual

Function Manual, 01/2011, 6SL3097-4AB10-0BP3

– Are identified by Fxxxxx.

– Can lead to a fault reaction.

– Must be acknowledged once the cause has been remedied.

– Status via Control Unit and LED RDY.

– Status via PROFIBUS status signal ZSW1.3 (fault active).

– Entry in the fault buffer.

– Are identified by Axxxxx.

– Have no further effect on the drive.

– The alarms are automatically reset once the cause has been remedied. No

acknowledgment is required.

– Status via PROFIBUS status signal ZSW1.7 (alarm active).

– Entry in the alarm buffer.

5.3 Fault and alarm messages

Show Quick Links

Table of Contents