The following t able describes t he labels in t his screen.
Table 145 Advanced Applicat ion > LLDP > LLDP- MED Configurat ion
LABEL
Port
*
Not ificat ion
Topology
Change
MED TLV Set t ing
Locat ion
Net work Policy
Apply
Cancel
33.8 LLDP-MED Network Policy
Click Adva nce d Applica t ion > LLD P > LLD P- M ED N e t w or k Policy ( Click H e r e ) t o display t he
screen as shown next .
Figure 212 Advanced Applicat ion > LLDP > LLDP- MED Net work Policy
Chapter 33 Link Layer Discovery Protocol (LLDP)
DESCRIPTION
This displays t he Swit ch's port num ber. Select * t o configure all port s sim ult aneously.
Use t his row t o m ake t he set t ing t he sam e for all port s. Use t his row first and t hen m ake
adj ust m ent s t o each port if necessary.
Changes in t his row are copied t o all t he port s as soon as you m ake t hem .
Select t o enable LLDP- MED t opology change t raps on t his port .
Select t o enable t ransm it t ing LLDP- MED locat ion TLV.
Select t o enable t ransm it t ing LLDP- MED Net work Policy TLV.
Click Apply t o save t he changes t o t he Swit ch's run- t im e m em ory. The Swit ch loses t hese
changes if it is t urned off or loses power, so use t he Save link on t he t op navigat ion panel
t o save your changes t o t he non-volat ile m em ory when you are done configuring.
Click Cancel t o begin configuring t his screen afresh.
GS2210 Series User's Guide
304